Sportsound SSR-200 Gen II Quick Start Guide
DD3159573
Rev 02
01 April 2019
201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Page 2 of 5
Follow the above steps in reverse order to power down the system.
Place all accessories in the storage case to avoid damage/theft.
Mixer Operation
•
Ensure all source equipment is turned on and operational (refer to
the appropriate pages of this guide).
•
For each input channel (source) in use, verify:
•
INSERT
jack has nothing plugged into it
•
GAIN
knob is set to an appropriate level
•
PAN
knob is set to the center position
•
MUTE
button is not depressed
•
Ensure the mixer is outputting
PHANTOM POWER
when using a first
generation Announcer’s Console
or when balanced condenser
microphones are plugged into the
mixer inputs.
• Depress the
PFL
button to listen
to each input channel without
interrupting the main mix.
With an input source playing
or while speaking into the
microphone, adjust the gain knob
and channel fader until the output
meter shows
0 dB
. Release the
PFL
button, and repeat this step for all
other channels in use.
Note:
The
PEAK
LED indicates
that the signal is close to
distorting (clipping).
•
Slowly bring up the channel and
master volume faders until the
output meter displays
0 dB
or
adequate volume is achieved. Red
LEDs indicate clipping. Also ensure
the
2 TRACK MONITOR
button is not
depressed.
Remember:
Bad input = bad output. No adjustment on the mixer
can make a poor source sound better. For best results, be sure to use
high-quality audio files from your MP3 player or laptop, and set the
device to near full volume.
Whenever red LEDs are illuminated on the mixer, this is generally a
sign that input settings need adjustment.
PROLONGED OVERLOAD
OUTPUT SIGNAL WILL DAMAGE THE AUDIO SYSTEM!
