ENGLISH
if the stby function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating and displaying
modulate. When the room temperature is below the setting, it will start to work again at the set power and displaying work.
stanD - By with aDDitional therMostat
The sTBy function is used if immediate stove switch-off is required when the set temperature has been reached.
By default the stBy function is always set on oFF (light
on).
stBy FunCtion set at oFF
(DeFaUlT seTTiNg)
if the sTBy function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating and displaying
MoDulate
. When the room temperature is below the setting, it will start to work again at the set power and displaying
work
.
stBy FunCtion set at on
When the sTBy function is activated (ON), the stove, upon reaching the set room temperature and exceeding it by 2°C,
will switch off after a pre-set default delay, displaying
stanD - By
.
When the room temperature is 2°C lower than the setting, the stove will start to work again at the set power
displaying WOrK.
CONTrOls prOCeDUre
press key 6 and
set CloCk
will appear
.
press key 2 several times to reach
set user.
Confirm using key 6.
press key 2 several times to reach
stanD By.
Using key 4 or 5 select at ON.
press key 6 to confirm and key 1 to return to the previous menus
up to the initial status.
The sTaND-By function is active
"keys loCkeD"
The menu allows to lock the display keys (like with mobile phones).
With the function engaged, every time a key is pressed, “
keys loCkeD
” will appear.
CONTrOls prOCeDUre
press key 6 and
set CloCk
will appear.
press key 2 several times until
user
is displayed.
press key 6.
"
Display
" will appear.
press key 2 until "
keys loCkeD
" appears.
Use keys 4 -5 to select enable/disable.
press key 6 to confirm and key 1 to return to the previous menus
up to the initial status.
J
onCe the FunCtion is aCtivateD, use keys 1 anD 5 at the saMe tiMe to loCk or unloCk the keyBoarD
48
