47
ENGLISH
INSTALLATION INSERTO 700 AIR
MINIMUM CLEARANCE
20
20
660
540
10
700
With front loading kit H=625mm
For the insert to operate correctly, a
minimum
side and rear space
must be guaranteed, as shown in figure 2; the coatings must be
made of
non-flammable
material.
figure 1
figure 2
GENERAL
The insert is supplied with a sliding base in iron that allows it to be
installed in a pre-existing chimney.
This sliding base allows the insert to be removed easily to load the
pellets inside the hopper and for any maintenance or cleaning at the
end of the season.
If there is no pre-existing chimney, one can be built using an insert-
holder pedestal (optional kit). In fact, the latter fixes the insert to the
ground.
ASSEMBLY: place the base in the chosen point and adjust the feet to
the desired height. Install a socket on the rear of the pedestal in a way
that the plug is accessible once installation has been performed. Fix
the pedestal to the floor using have-duty steel plugs with diameter
of 8mm. Take the sliding base and fix it to the pedestal.
Please note: If our pedestal is used, a slot must be created in the flue
pipe to allow the pellet hopper level to be checked, thus avoiding
spillage when it is being topped up.
ASSEMBLY MUST BE CARRIED OUT BY QUALIFIED PERSONNEL!
Summary of Contents for INSERTO 700 AIR
Page 2: ...2 Applicare etichetta dati technici ...
Page 173: ...173 ...
Page 174: ...174 ...
Page 175: ...175 ...
