60
ENGLISH
IT IS FORBIDDEN TO USE THE DEVICE WITHOUT A PARTITION (A) AND FLAME
GUARD (B).
REMOVAL WILL COMPROMISE THE SAFETY OF THE PRODUCT AND RESULT IN
THE IMMEDIATE NULLIFICATION OF THE WARRANTY PERIOD.
IN THE EVENT OF WEAR OR DETERIORATION, REQUEST THE PART'S
REPLACEMENT FROM THE AFTER-SALES SERVICE
(REPLACEMENT DOES NOT FALL WITHIN THE PRODUCT WARRANTY AS THE
PART IS SUBJECT TO WEAR).
A B
DATE/TIME
This menu allows the date and time to be set.
To set: OK >
SETTINGS > DATE/TIME
.
LANGUAGE
This menu allows the preferred language to be selected.
The languages available are: Italian - English - German - French - Spanish - Portuguese.
To set: OK >
SETTINGS > LANGUAGE.
DEGREES
This menu allows you to set the desired unit of measurement.
To set: OK >
SETTINGS > DEGREES
FIRST IGNITION SETTINGS
Once the power cable at the back of the generator has been connected, move the switch, also located on the back, to (I).
The switch at the back of the generator powers the generator board.
The generator remains off and an initial screen appears on the panel, displaying OFF.
GENERAL WARNINGS
Advice to follow for the first start-ups of the product:
During the first hours of operation, there may be some smoke or
odours, but they are due to the normal “thermal break-in” process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Ventilate the room well
If present, remove any majolica parts from the top of the
product
Activate the product at the maximum power and temperature
Avoid remaining in the room for a long time
Do not touch the surfaces of the product
Notes:
The process is completed after a few heating/cooling cycles.
Do not use for the combustion of elements or substances other than
those indicated in the manual.
Before turning on the product, it is necessary to perform the
following checks:
If it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
The pellet hopper must be completed loaded
The combustion chamber and the burn pot must be clean
Make sure that the fire holder, the ash pan and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Check that the power cord is properly connected
The bipolar switch (if present) must be set to position “1”.
Summary of Contents for INSERTO 700 AIR
Page 2: ...2 Applicare etichetta dati technici ...
Page 173: ...173 ...
Page 174: ...174 ...
Page 175: ...175 ...
