ENGLISH
OPERATION AND LOGIC
IGNITION
Once the points listed previously have been checked, press key 1 for three seconds to ignite the stove. 15 minutes are available for the ignition
phase. After ignition and having reached the control temperature, the stove interrupts the ignition phase and passes to STARTING.
STARTING
During the start-up stage, the stove stabilises combustion, increasing it gradually, to then start ventilation and switch to the WORK mode.
WORK
During the work phase, the stove reaches the set power; see following item.
SET POWER ADJUSTMENT
Set the functioning power from 1 to 5 (settable using keys 2 - 3).
Power 1 = minimum level - Power 5 = maximum level.
SET H2O TEMPERATURE ADJUSTMENT
Set the boiler temperature from 65 - 80°C (settable using keys 4 - 5).
PUMP OPERATION
The pump activates water circulation when the temperature of the water inside the stove reaches approx. 60°C. As the pump always functions
above 60°, an always-open heating area is recommended to make product functioning homogeneous, avoiding overheating blocks. Normally
this area is defined as a “Safety zone”.
ENVIRONMENTAL TEMPERATURE (
in the applicable models)
The front ventilation can be activated/deactivated and the room temperature controlled by means of the room probe (as per standard). (See
the ''enable fan'' chapter on the following pages.)
BURN POT CLEANING
During the work stage, the stove has an internal counter which cleans the burn pot after a set amount of time.
This stage will be shown on the display, it will bring the stove to a lower power level and will increase the fumes motor for a programmed
amount of time. When the cleaning stage is finished, the stove will continue its work, going back to the selected power level.
MODULATION and H-OFF
As the water temperature approaches the set point, the boiler starts to modulate automatically bringing itself to the minimum power. If the
temperature increases beyond the set point, it will automatically switch off indicating
H-OFF
and will automatically go back on when the
temperature drops below the set point.
SWITCH-OFF
Press key 1 for three seconds.
When the operation has been performed, the appliance automatically enters the switch-off phase, blocking the supply of pellets.
The fumes motor and the hot air ventilation motor will remain on until the temperature of the stove has dropped below the factory
parameters.
RE-IGNITION
The stove can only be re-ignited automatically or manually when the cooling cycle conditions and the preset timer have been satisfied.
J
NO IGNITION
FIRST IGNITION COULD EVEN FAIL AS THE AUGER IS EMPTY AND IS NOT ALWAYS ABLE TO LOAD THE BURN POT
WITH THE REQUIRED AMOUNT OF PELLETS ON TIME TO REGULARLY START THE FLAME. IF THE PROBLEM OCCURS
AFTER ONLY A FEW MONTHS WORKING, CHECK THAT ROUTINE CLEANING STATED IN THE STOVE BOOKLET, HAS
BEEN CARRIED OUT CORRECTLY.
DO NOT USE ANY INFLAMMABLE LIQUIDS FOR IGNITION!
DO NOT ALLOW THE BAG OF PELLETS TO COME INTO CONTACT WITH THE BOILING HOT STOVE DURING THE FILLING PHASE!
IN THE EVENT OF CONTINUOUS NO IGNITION, CONTACT AN AUTHORISED TECHNICIAN.
IT IS FORBIDDEN TO USE THE APPLIANCE WITHOUT THE DIVIDER AND/
OR GLASS PROTECTION (SEE THE FIGURE TO THE SIDE). ITS REMOVAL
JEOPARDISES THE SAFETY OF THE PRODUCT AND IMMEDIATELY VOIDS THE
WARRANTY PERIOD. IN THE CASE OF WEAR OR DETERIORATION REQUEST
AFTER-SALES ASSISTANCE FOR REPLACEMENT OF THE PART (REPLACEMENT
THAT IS NOT UNDER GUARANTEE AS THE COMPONENT IS SUBJECT TO WEAR).
BURN POT UPPER DIVIDER
GLASS PROTECTION
46
