Installation
Observe the permissible ambient temperature of the controller. This can be hot during operation.
When installing several pieces side by side, it is recommended to observe the minimum gap
between them
–
5.0 cm. Vertical operating positio
n.
Screw the controller onto a flat surface (wall, zeď etc.)
Unscrew the screws of the cover and open the driver cover.
Pass the cables through the grommets (maximum cable cross
-
section: 1.5 mm2).
Make the link according to the appropriate scheme.
When closing the cover, properly arrange the internal cables.
Insert the short
-
circuit protection into the power circuit.
