DGM02
Device Manual
Made in Italy
DALCNET S.r.l.
36077 Altavilla Vicentina (VI)
–
Italy
Via Lago di Garda, 22
Tel. +39 0444 1836680
–
Rev.
06/12/2022 -
Pag.
12/32
B
US
3
Bus 3 is related to the third BUS port of the product. The DALI protocols.
You can set this port in the following configurations:
Not Set
DALI controller
DALI config
In this menu it is possible to assign the "OFFSET" and "CHANNELS RANGE" of the 64 DALI
nodes to the BUS 3 channels.
The “DALI channels offset” allows you to assign the number of the starting slide to the first
DALI address.
The “DALI channels range” allows you to set the number of channels you want to use in
BUS 3.
The BUS can be disabled by means of the “MUTE” flag or by setting the
bus configuration in
“NOT SET”. With these functions you disable the bus and turn off the power supply on the
DALI bus.
NOTE: when addressing DALI devices in DALI config mode, it is recommended to set the range to 64, maximum value and only
after returning to the DALI Controller configuration and addressing the devices change the range to the desired value.
After modifying the settings, click on the “
APPLY
” button at the top right, otherwise the changes will be lost.
On the other hand, with the “
CLEAR
” button the changes are
cancelled.
