DGM02
Device Manual
Made in Italy
DALCNET S.r.l.
36077 Altavilla Vicentina (VI)
–
Italy
Via Lago di Garda, 22
Tel. +39 0444 1836680
–
Rev.
06/12/2022 -
Pag.
14/32
SETTINGS: DALI CONFIG
–
BUS 3
NOTE: before proceeding with the addressing and configuration of the DALI devices, it is necessary to set BUS 3 in
DALI Config mode.
A
DDRESSING
By clicking on "DALI config" from the pop-up menu, we enter the DALI device addressing interface.
At the top right are the following commands:
"
SCAN
": performs the acquisition of DALI nodes already addressed;
"
ADDRESS ALL
": performs the addressing of all DALI nodes, the address devices will be displayed in a list;
"
REMOVE
ALL
": removes the addressing to all DALI nodes.
NOTE: before making a complete addressing of the system it is necessary to send a “REMOVE ALL” command.
I
DENTIFICATION OF ADDRESSED DEVICES
After addressing, it is possible to flash the node just addressed, so that it can be visually identified.
