DGM02
Device Manual
Made in Italy
DALCNET S.r.l.
36077 Altavilla Vicentina (VI)
–
Italy
Via Lago di Garda, 22
Tel. +39 0444 1836680
–
Rev.
06/12/2022 -
Pag.
15/32
A
DDRESS CHANGE FROM THE DEVICES ALREADY ADDRESSED
To change the address of the single DALI node, previously addressed, it is necessary to enter the new node value (eg from 0 to
63) to the right of the flashing button of the node itself and click the "APPLY" button which will appear immediately on the right.
A
SSOCIATING A GROUP WITH A DALI ADDRESS
By clicking on one of the 16 boxes depicting the available groups (ie from 0 to 15) it is possible to associate the desired address
to a DALI Group. Subsequently, by pressing the “APPLY” button that appears at the top, the command is sent on the DALI BUS.
As confirmation of the assignment of the address to the group, the box changes from red to blue
