Take piece A (with the C and D screws slotted into it), and place this over the central vertical support on
piece K. Make sure the screws line up with the holes in G and F. Using the Allen Key (piece E) screw the
screws into G and F so that piece A is held securely in place.
Take piece B and screw this into the
small hole below the metal plaque on
the central vertical support. This can
be loosened so you can move the top
support up to fit your canvas/board
onto the easel and then tightened to
hold your work in place.
Your easel is now complete and ready
to use. The height can be adjusted by
pulling out the metal loop under the
horizontal support and moving the bar
up and down. Releasing the metal loop
will hold the bar in place.
Page 02 / 02
