9
UK
DE
DK
CN
FR
Every room has its own distinctive acoustics, which influence the way we experience sound from
a speaker. the sound you hear consists of both direct sound from the speakers and reflected
sound from the floor, and walls. the latter will affect how you experience the sound. As a basic
rule, try to avoid large, hard and reflective areas in the immediate vicinity of your loudspeakers as
it will typically cause strong reflections, which might disturb the precision and spatial effect of the
sound reproduction. Soft items such as carpets, curtains etc. might help if the sound is too bright.
Both the amount and quality of the deep bass depend on the size and shape of the room, and the
position of the speakers. Positioning the speakers near a side or back wall will accentuate the
bass. A corner location will accentuate it even more, but will also increase the reflections.
NOtE: the flow damping foam material mounted on the back of the DALI PHANtOM H Series
should not be removed. It will assist in managing bass/midrange reproduction by damping
resonances in the cavity behind the open-back woofer.
4.1 Mounting the dogleg brackets
DALI PHANtOM H Series incorporates dogleg brackets for wall mounting. the brackets attach the
loudspeaker firmly to the rear of the surface on which it is mounted. the dogleg brackets extend
out at a 90-degree angle when the screws are tightened (see figure 3). the screws should be
tightened so that the loudspeaker sits securely in place – but be careful not to over tighten the
screws. to tighten the screws, use the 3mm Allen key (enclosed in the package).
If using an Allen bit it should be used with a hand bit screwdriver or a drilling machine with build-in
torque setting. If using a drilling machine, set the torque to the minimum setting. the screws are
appropriately tightened, when the gasket on the rear of the speaker is compressed and the bezel
of the speaker is flush with the mounting surface.
If you need to remove the loudspeaker, loosen the screws approximately 5 to 20 turns counter
clockwise and the brackets will loosen their grip.
NOtE: Do not unscrew more than 20 to 25 turns or the brackets may fall off the screws.
If you are mounting the loudspeaker in very thick wall material, it might be needed to dismount the
dogleg brackets from the screws and afterwards mounting them upside down. Opposite mounting
of the doglegs will make it possible to mount the loudspeaker in boards with up to 2.75”/70 mm
thickness (see figure 4).
4.2 Grille
the metal grille is attached by means of magnets incorporated in the top of the speaker. carefully
place the grille so that it covers the top of the speaker, and the magnets will secure it.
NOtE: On the inside of the grille there is a piece of non-woven. the non-woven is on the grille
to protect the drivers against dust and dirt. therefore the non-woven must remain on the grille.
the supplied DALI logo badge can optionally be mounted on the grille. to mount the logo badge,
remove the protective film from the rear side of the logo badge and position the logo on the grille
in the desired position (see figure 5).
Autogoods “130”
130.com.ua
