11
Open the file of current picture
；
[File]
There are three icons when the cursor points to the thumbnail. They are:
[Remove] Remove the thumbnails but not delete the local files. The removed one will not appear in the PDF,TIFF or
JPG;
[Insert] Insert a “picture set” before the current “picture set”;
[Re-‐scan]Re-‐scan the current “picture set” and replace the original.
5. Curve operation
[Auto Curve]Automatically generate curves to flatten the surface.
[New]Click to switch the picture to original. Click the “point” along the page from right to left both up and down side
of page. Right-‐click the point and set it as an “inflection points” and it is the junction point of left page and right page.
Finish the setting and click [flattening].
[Add] Add the point at anywhere along the page line to enhance the effect of flattening.
[Move]Move the point to the right position.
[Del] Delete the extra point that you click.
[Clear] Delete all the points.
[Single width]You can set the width of page;
[Hand measuring]Click the left and right edge of page and measure the width automatically.
[Empty]Delete the measure-‐line.
[Inclination angle]Set the degree of tilt and click anywhere after to correct the page. Negative number means
clockwise and positive number means counterclockwise.
[Hand measuring]Click from left to right along the page to set the measure-‐line and click the
[Slant correction] of public panel to correct the picture.
6. Public panel.
[Processing Setting]You can switch between [black & white] and [colorful], choose any one and
click the [Automatic] to switch. The value can be adjusted.
[Remove finger]Checkmark it and click the [Automatic], the fingerprint can be automatically
removed.
[Flatten operation]Checkmark it and click the [Automatic] to deal with the current image.
[Slant correction]Click the [Automatic] to deal with the current image.
[Adapt to Height]Maximize the display based on the height.
[Adapt to Width]Maximize the display based on the width.
[Actual size]Show the actual size.
[Rectangle]You can draw one rectangle and move it to any position. Right click until pop up
“clear”, click it and the content of the rectangular area is cleared, or you can save the image.
[Slant correction]This icon works with [inclination angle] and [hand measuring].
[Correct only Chinese]Slight correct the slant page.
[Switching the image]Switch between "original" and “processed image".
[Move]You can move the current picture.
