DAS-300 E
17
Dallmeier electronic
6.3
Attaching the chassis slides
1. Attach the chassis slides to the DAS-300 E sides using 3 M3x4 screws for each side.
2. Assemble the left and right chassis latches using the special chassis latch screws.
Ensure the latches are correctly orientated. Both spring arms must be located against its
stop.
On the right hand the shorter arm must be at the top, on the left it must be at the bottom.
6.4
Attaching the guide rails
1. If necessary, loosen both clamping screws to change the length of the guide rails before
attaching them.
2. Fit the guide rails into the rack.
3. Attach the guide rails to both front and rear side of the rack using two washers and
screws for each side. The screws should be left loose enough to allow for sideways
movement of the rails.
4. Tighten the two clamping screws.
Fig. 6-2: Installation of the left guide rail
Chassis Latch Stop
Chassis Latch
Chassis Slide
Fig. 6-1
Rear Rack Post
Clamping Screws
Guide Rail
Slide Washer (x4)
Slide Screw (x4)
Front Rack Post
