MicroStreamer-PoE
www.dallmeier.com
28
9 Network
9.1
Basic settings
The network settings of the device can be configured manually or automatically assigned
by a DHCP (Dynamic Host Configuration Protocol) server.
In order to avoid network conflicts, you should clarify if intended network settings are per-
mitted. In particular, the allocation of an already used IP address may result in malfunctions.
Open the
Network settings
dialogue via
Network
>
Basic settings ...
.
Fig. 9-1
Default settings
Connection type:
automatic
DHCP:
deactivated
Hostname:
ipcam
IP address:
192.168.2.28
Netmask:
255.255.255.0
Gateway:
192.168.2.1
Allow IP-Finder remote network configuration:
activated
NOTICE
Incorrect settings may result in the device being no longer available via
the network.
For troubleshooting purposes, write down the
MAC address
and all new
settings before changing the configuration.
Note the explanations below.
Select the transfer rate and the duplex mode from the drop-down list
Connection type
.
The “
Connection type
>
automatic
” (Autonegotiation) is suitable for most applications.
