MicroStreamer-PoE
www.dallmeier.com
55
Fig. 12-2
Function
Select the
Function
in which case the relay should be switched.
To switch the relay in case of a camera failure, select the
“
Function > Error
”
and activate
the
“
Camera
”
checkbox.
Timer (Holding Time)
Set the
Timer
to
On
to enable the relay activation timer (holding time).
In the
Time (sec.)
field, enter the relay activation time in seconds.
Type
In the
Type
field, select whether the relay should act as
make contact
(NO - Normally
Open) or as
break contact
(NC - Normally Closed).
Finally confirm with
OK
.
12.3
Data display
The data display function provides the embedding of data transferred from external de-
vices/applications (via DaVid Protocol).
The embedded data is displayed in live mode of DaVid Protocol capable devices/appli-
cations. A recording of the embedded data has to be configured separately. For detailed
information refer to the separate documentations.
12.3.1
Filter
The external transferred data can be filtered before embedding.
The filtering (selection) only takes effect on external sent data.
Open the
Data display - Filter
dialogue via
Interfaces
>
Data display
>
Filter ...
.
