MicroStreamer-PoE
www.dallmeier.com
59
Select all relevant settings which should be exported to the configuration file by acti-
vating the related checkbox.
Confirm with
OK
.
Follow the instructions of the download dialogue and save the configuration file to a
data storage device.
The configuration file name contains the IP address of the related device.
13.2.2
Upload
The saved configuration file can be transferred to an individual device. This allows the re-
covery of the configuration of the device that is currently connected.
In addition, the configuration file can also be transferred to several devices simultaneously.
This is a very effective method of configuring several devices identically in terms of certain
configuration groups.
13.2.2.1 Configuration recovery
To recover the configuration of an individual device, the connection to the device must be
established first (see section “
Open the
Configuration file management
dialogue via
Service
>
Configuration file
>
Upload ...
.
Fig. 13-3
Click
Browse…
.
Select the relevant configuration file on your data storage device.
Confirm with
OK
.
At the end of the transfer the list of transferred (or skipped) configuration settings is dis-
played.
13.2.2.2 Configuration transfer to several devices
As a precondition all relevant devices must be located in the same LAN (with suitable
cabling and a separate IP address for each device). In addition, the access rights to all
devices must be identical (same user name and password).
Before the configuration file can be transferred, it must be saved as described above.
However, the configuration of the
Network settings
must not be included in the configu-
ration file. If these settings were included, the same IP address would be transferred to
all devices. Since, however, every IP address in a LAN must be unique this would cause
massive problems in the network.
