Dallmeier electronic GmbH & Co.KG | Bahnhofstr. 16, 93047 Regensburg, Germany | +49 941 8700-0 | dallmeier.com
All trademarks identified by ® are registered trademarks of Dallmeier electronic GmbH & Co.KG.
Third-party trademarks are named for information purposes only. Dallmeier electronic respects the intellectual property of third parties and always attempts to ensure the complete identification of third-party
trademarks and indication of the respective holder of rights. In case that protected rights are not indicated separately, this circumstance is no reason to assume that the respective trademark is unprotected.
Specifications subject to change without notice. Errors and misprints excepted. Pictures may differ from the actual product.
© 2021 Dallmeier electronic V1.0.0 2021-09-22 2/2
Panomera® Maintenance
Important information for inspection and maintenance of Panomera® S4 and S8 systems
Housing Cleaning
Regular cleaning of the Panomera® housing is necessary for error-free operation. Contamination of the front glass, for example, could lead
to poor image quality. On the other hand, heavy soiling of the cooling fins could endanger heat exchange and thus fault-free long-term
operation.
Please note that regular cleaning of the housing is not only necessary for optical reasons.
First remove all foreign objects (cobwebs, leaves, etc.) from the housing, especially:
1
5
2
4
3
❶
from the front glass.
❷
between the cooling fins on the back.
❸
between the ventilation holes at the back.
❹
Clean the surface of the housing soft, dry and antistatic cloth.
Do not use cleaning agents to avoid damaging the surface.
❺
Clean the front glass of the Panomera® with a silicone-free cotton cloth.
Do not use a household glass cleaner, but a special cleaner recommended by Dallmeier (Flux glass cleaner).
Avoid strong rubbing and do not allow residues of the cleaning agent to dry on the front glass.
Front Glass Check
After cleaning the housing, the front glass of the Panomera® should be checked. In addition to observing any scratches, the seal of the front
glass in particular should be checked thoroughly. Depending on the prevailing environmental conditions, the seal may be damaged by cracks
or shrinkage. As a result, penetrating moisture can lead to fogging of the glass from the inside and, in extreme cases, to damage to the optics
and electronics.
Note that a front glass with a damaged seal must be replaced immediately to avoid consequential damage.
