7
Dallmeier electronic
PView Station PVS IV
Observe the rated voltage
The unit can be damaged or destroyed by the application of an incorrect voltage.
The mains voltage must always match the rated voltage of the unit. The rated voltage is
specified on the rating plate of the unit.
Observe ratings
Unsuitable ambient conditions and improper installation (mainly too high ambient tempera-
ture and insufficient ventilation) may reduce the unit’s life cycle. Ensure compliance with the
stated operating conditions (see technical data), requirements at the installation site and, if
applicable, maintenance regulations.
Expansion components/peripheral devices
Use only expansion components conforming with the technical data of the unit. Inappropriate
peripheral devices may result in the violation of local laws and regulations and damages
to the unit. Furthermore, the use of peripheral devices that are not certified by Dallmeier
electronic results in loss of warranty. In case of doubt, contact the sales partner responsible
for your area.
Do not move while in operation
Strong vibrations can cause damage to the unit, in particular to the hard disk(s). Therefore,
do not bump the unit or move it in a jerky motion while in operation. Instruct the cleaning
personnel accordingly if necessary!
Do not open the unit
Do not open the housing of the unit. There are no components inside the unit that require
maintenance by the user. The inspection, maintenance and repair with an open housing
must only be carried out by trained and authorized professionals (installer).
Penetration of foreign bodies and liquids
No objects or liquids may be allowed to get into the device. In this case, immediately dis-
connect the unit from the power supply (pull out the power plug). Please contact the sales
partner responsible for your area.
Measures to be taken in the event of damage and burnt smell
If you notice burnt smell or formation of smoke from a unit, immediately disconnect it from
the power supply (pull out the power plug). Please contact the sales partner responsible
for your area.
Disposal
Disconnect the unit from the power supply. Remove all connected units and system com-
ponents. Return the unit to your respective sales partner.
