WSD-2 HD
24
Dallmeier electronic
8 Network settings
8.1
General settings
The basic network settings are made in the
Network settings
dialogue.
NOTE
After the network settings have been changed, the connection
to the DCM-1 is broken. You then have to log in again.
Ø
Select
Common settings
>
Network ...
.
Fig. 8-1
Ø
First select the appropriate
Link speed
for the current LAN. In most cases the default
-
setting
automatic
will suffice.
If you check the
DHCP
option, you will connect to the existing network without any further-
configuration. No other information (IP address, etc.) must be entered. In this case the
module takes its network settings from a central DHCP server.
If DHCP is not selected, enter the
IP-Address
for the module and also the
Netmask
and
the
Gateway
.
Ø
Save your settings by clicking on
OK
.
Ø
Log back on to the system.
8.2
Alarm host
If you wish to configure an alarm host, the module can send alarm messages via the
LAN.
A software package (for example PGuard) to evaluate the messages must be running on
the receiving computer.
Ø
Select
Common settings
>
Alarm hosts ...
.
If you have not previously configured an alarm host, only the
New ...
option will be dis-
played.
