WSD-2 HD
20
Dallmeier electronic
7.3.2
Timeserver
Ø
Select the
Timeserver
tab.
Fig. 7-6
Ø
Activate the
use timeserver
checkbox.
Ø
Enter the IP adress of the
Timeserver
.
Ø
Finally confirm with
OK
.
7.4
Video standard
Ø
Open the Video standard dialogue via
Common settings
>
Video standard ...
.
Fig. 7-7
Ø
Set the
Standard
.
Ø
Confirm with
OK
.
7.5
COM interface
External devices, such as a dome or PTZ camera, can be connected to the module’s COM
interface.
These devices are controlled by the evaluation software (PView, SeMSy
®
, etc.). The control
signals are sent to the module using the DaVid protocol. This then forwards the signals to
the external device.
Ø
Open the
Interfaces
dialogue via
Common settings
>
Interfaces ...
.
Fig. 7-8
Ø
Set the
Function
to
Crosslink
.
Ø
Make the necessary settings.
Ø
Finally confirm with
OK
.
