WSD-2 HD
25
Dallmeier electronic
8.2.1
Setting up
Fig. 8-2
Ø
Click on the
New ...
selection.
The selection is expanded to include the Alarm host 1 entry.
Fig. 8-3
Ø
Click on Settings.
Ø
Click on the
Name
field.
Ø
Enter the name of the computer which is to receive the alarm notifications from your
DCM-1.
Ø
Click on the
IP address
field and enter the IP address of the receiving computer (alarm
host).
All the settings for the selected host are only applied when the checkbox located next to
active
is checked.
Selecting messages
To select the messages to be sent to the alarm host, open the
Messages
tab.
Fig. 8-4
Ø
Click on
Messages
.
The following messages can be transmitted:
l
harddisk failure
Defective hard disk
l
track deleted
The recording track has been deleted.
l
power supply status
Notification in the event of a power supply failure
