WSD-2 HD
35
Dallmeier electronic
10 Saving the configuration
The configuration of each module can be exported as a file and thus backed up.
In addition to re-establishing an individual module, the configuration can also be transferred
to several modules simultaneously.
10.1
Saving the configuration file
Ø
To transfer and save the configuration on the configuration PC, click on
Config File
>
Save
.
You can decide which configuration groups should be included in the backup in the
Config
File Management
dialogue.
Fig. 10-1
IMPORTANT
If you wish to transfer the configuration at a later date to several
devices, you must not save the
Network settings
configuration
group.
IMPORTANT
If you wish to transfer
Track settings
and
Video standard
to
a module which originally had different settings in these areas,
the module’s images or tracks must be deleted.
Ø
Click on
OK
after the selection has been made.
Follow the instructions in the download dialogues and save the configuration file. The configu
-
ration file is a plain text file. The file name contains the IP address of the relevant module.
10.2
Sending the configuration file
The configuration file saved on the configuration PC can be sent to an individual module.
This allows the configuration to be restored on the module that is currently connected.
In addition the configuration file can also be sent to several modules at the same time. This
is a very effective method of configuring several modules identically in terms of certain
configuration groups.
