WSD-2 HD
36
Dallmeier electronic
10.2.1
Individual module
To restore the configuration of an individual module, first establish a connection to this
module.
Ø
Open the
Config File Management
dialogue via
Config File
>
Upload
.
Fig. 10-2
Ø
Click on
Search
(
Durchsuchen
).
Ø
Select the relevant configuration file on your configuration PC.
Ø
Click
OK
.
At the end of the transfer the system will display a list of transferred (or skipped) configu
-
ration groups.
Fig. 10-3
10.2.2
Several modules
The prerequisite for this method is that all the relevant devices are integrated in a LAN (with
suitable cabling and a separate IP address for each device). In addition the password must
be identical for all the devices.
Before the configuration file is sent, it must be saved as described above. However, the
Network settings
configuration group must not be included in the file that you save.
If these settings were included, the same IP address would be sent to all the modules.
Since, however, every IP address in the LAN must be unique, this would cause massive
problems in the LAN.
