20
•
Software and Hardware Setup
!
Static electricity can damage electronic components. It’s critical that you discharge any
static electrical charge by touching a grounded surface, such as the metal computer chassis,
before performing handling the camera hardware.
Power Connector
WARNING:
It is extremely important that you apply the appropriate voltages to
your camera. Incorrect voltages may damage the camera. Input voltage
requirement: +12 VDC to +24 VDC (± 5 %), 2 Amps. Before connecting power to
the camera, test all power supplies.
Figure 7: 12-pin Hirose Circular Male Power Plug—Power Connector
Table 6. Power Plug Pinout
Pin
Description
Pin
Description
1
GND
7
OUT2+
2
+12 V to +24 V DC
8
OUT2-
3
OUT1-
9
NC
4
OUT1+
10
NC
5
IN1-/Trigger
11
IN2+/Trigger
6
IN1+/Trigger
12
IN2-/Trigger
WARNING: When setting up the camera’s power supplies follow these guidelines:
•
Apply the appropriate voltages.
•
Protect the camera with a 2 amp slow-blow fuse between the power supply and
the camera.
•
Do not use the shield on a multi-conductor cable for ground.
1
2
3
4
5
6
7
8
9
10
11
12
!
