Camera Operation
•
77
Image Format Controls Category
The camera Image Format controls, as shown by CamExpert, group parameters used to
configure camera pixel format, and image cropping. Additionally, a feature control to select
and output an internal test image simplifies qualifying a camera setup without a lens.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne
DALSA Support or third party software usage—not typically required by end user
applications.
Figure 27 Image Format Controls as shown in CamExpert
The following table describes these parameters along with their view attribute and minimum
camera firmware version required. Additionally the table will indicate which parameter is a
member of the DALSA Features Naming Convention (DFNC), GenICam Standard Features
Naming Convention or custom camera feature.
Name
Width
Display Name
Width
Name Space
SFNC
Firmware Release
00
Visibility
Beginner
Access
Read-Write
Type
Integer
Values
Minimum: 512
Maximum
: SensorWidth - OffsetX
Increment: 128
Name
Height
Display Name
Height
