106
Appendix: X-I/O Module Option
X64-AN Quad User's Manual
X-I/O Module Sapera Interface
Sapera version 5.30 (or later) provides support for the X-I/O module via an I/O class and
demonstration program. Users can use the demonstration program as is, or use the demo program
source code to implement X-I/O controls within the custom imaging application.
This section describes configuring the X-I/O module power up state, using the X-I/O demo program,
and describes the Sapera Class to program and read the X-I/O module along with sample code.
Configuring User Defined Power-up I/O States
The X-I/O module power up state is stored onboard in flash memory. User configuration of this initial
state is performed by the Device Manager program. Run the program via the windows start menu:
(
Start • Programs • Teledyne DALSA • X64-AN Quad Device Driver • Device Manager
).
The Device Manager provides information on the installed X64-AN Quad board and its firmware.
With an X-I/O module installed, click on
XIO Board – Information
, as shown in the following
figure.
