108
Appendix: X-I/O Module Option
X64-AN Quad User's Manual
General I/O Module Control Panel
The I/O module control demo presents the I/O capabilities of the installed hardware. The following
figure shows the X-I/O module connected to the X64-AN Quad board.
Output Pins
: The first column displays the current state of the eight output pins (I/O Device #0).
The startup default state is user configured using the Device Manager program.
The state of each output can be changed by clicking on its status button.
Use the Signal Output drop menu to select the output mode (Tristate, PNP, NPN).
Input Pins
: The second section provides input pin status (I/O device #1). Note that this program is a
demo, therefore no action takes place on an input event.
The first column reads the logic level present on each input. The Input Level drop menu changes
the logic level from 5V TTL to 24V logic. Use the Device Manager program to select the default
logic level type.
The second column demonstrates activating interrupts on individual inputs. In this demo program,
use the Enable box to activate the interrupt on an input. The Count box will tally detected input
events. Use the Signal Event drop menu to select which input signal edge to detect. The Reset
button clears all event counts.
