UNPACKING AND SETTING UP
Replacing the Cutting Blade
Make sure to disconnect the machine from the
power supply before fitting or replacing the cut-
ting blade or when doing any maintenance on
the machine.
●
Remove blade guard.
●
Block the sawing spindle with the 5 mm
Allen wrench.
●
Unscrew the 19 mm. hexagon nut with the
wrench and remove the saw flange.
(Attention: Left-handed screw threading)
●
Clean the saw flanges.
●
Fit the new cutting blade on the center ring
of the motor flange. (Check the direction of
rotation and make sure the blade is well
centered)
●
Mount saw flange and tighten with the
hexagon nut.
●
Place the blade guard and tighten with the
2 knobs.
DALTILE 828 BrS OPERATING MANUAL V02/2004R1
PAGE 13
828 28-10-2004 09:47 Pagina 13
