DALTOOL SAFETY
●
TOOL MAINTENANCE.
It is important to keep tools clean and in
good working order. This will result in
optimal performance of the machine.
Always follow the maintenance instructions
for proper tool maintenance.
●
DISCONNECT TOOLS.
It is important to disconnect the power tool
before servicing the equipment. This
should be done when changing accesso-
ries on the machine, changing blades and
for other such things.
●
REDUCING ACCIDENTAL STARTING OF
MACHINE
It is important to be sure that the
switch is in the OFF position
before you plug the machine into
an electrical outlet.
●
EQUIPMENT ACCESSORIES.
It is important that you refer to the owner’s
manual for determining what are the
recommended accessories to use with this
type of equipment. Using accessories that
are not recommended in the owner’s
manual may increase the risk of personal
injury and/or to people that are within
close proximity of the machinery.
●
CHECKING THE EQUIPMENT FOR
DAMAGED PARTS.
It is important to inspect the power tool
before using it to check for damaged
parts. Any part of the machinery that is
damaged should be checked carefully to
determine whether or not it should be
used and whether or not it can function
properly for its intended use.
It is important to check all the moving parts
of the machinery for proper alignment and
/or possible binding. All broken or dama-
ged parts should be properly repaired or
replaced. If these parts are not repaired
or replaced the proper operation of the
machine could be negatively affected.
Damaged saw blades should be replaced
immediately.
●
BLADE ROTATION DIRECTION AND
FEED ROTATION.
Always feed work into a blade in the
direction of rotation. The blade should
always be installed so that the rotation is in
the direction of the arrow imprinted on the
side of the blade and the blade guard.
●
NEVER LEAVE A TOOL RUNNING
UNATTENDED – TURN POWER OFF
It is important never to leave a tool running
when not in use. Also never leave the tool
until the blade has come to a complete
stop. It is important to always turn the
power tool OFF when leaving the work
area or when a cut is finished.
PAGE 6
DALTILE 828 BrS OPERATING MANUAL V02/2004R1
828 28-10-2004 09:47 Pagina 6
