INSTALLATION INSTRUCTIONS
INSTRUCTIONS FOR INSTALLATION
This appliance shall be installed only by authorised personnel and in accordance with the
manufacturer's installation instructions, local gas fitting regulations, municipal building codes,
water supply regulations, electrical wiring regulations, AS 5601 - Gas Installations
and
any other statutory regulations.
Gas safety Regulations (Installation & Use)
Installation Instructions
POSITIONING THE APPLIANCE
Combustible Surfaces - Any adjoining wall surface situated within 200mm from the edge of any
hob burner must be a suitable non-combustible material for a height of 150mm for the entire
length of the hob. Any combustible construction above the hotplate must be at least 700mm
above the top surface of the bench and no construction shall be within 450
mm above the top of
the burner. Allow a 10mm minimum clearance below the hotplate.
Ventilation - Ventilation must be in accordance with AS5601 - Gas Installations. In
general, the appliance should have adequate ventilation for complete combustion of gas, proper
flueing and to maintain temperature of immediate surroundings within safe limits.
PRE-COMMISSIONING THE APPLIANCE
When unpacked, check that the following parts are included with the appliance:-
x
Instruction and Installation Book
x
Pan Supports
x
Burner Assemblies
x
Adhesive sealing strip and fixing clamps & screws
x
½ BSP Elbow & Seal
x
Universal LPG conversion kit comprising an Universal LPG jet for each burner and a
self-adhesive label for mending Gas Category on the appliance Rating Label.
8
