Reference
Version
Document
Lang.
Page
244-ENG
09-01-2018
244 DAN DRYER Turbo (with nozzle)
Maintenance and service manual
ENG
7 of 12
DAN DRYER A/S • Tåsingevej 2 • DK-8940 Randers SV • Tel: +45 86 41 57 11 • Email: info@dandryer.dk
Cleaning the inside of the machine
7. Use compressed air (max. 8 bar) to remove dirt
and carbon dust from the motor and motor
housing. If compressed air is not available,
parts may be cleaned with a soft brush or
gently with a vacuum cleaner.
9. The heating element is placed at the bottom of
the motor housing. Clean it using compressed air
(max. 8 bar). Blow from both sides, and be
careful not to damage the heating element.
10. Put the small rubber gasket back in place at
the bottom of the fan housing. Be careful
not to turn it upside down, cf. photo ref. 11.
12. Reconnect motor wires to the timer unit
(appearance depends on the timer type).
Please be careful not to damage wires.
8. Lift the large rubber gasket out of the top of the
motor housing. Clean it and degrease with alcohol.
Clean the small rubber gasket placed at the bottom
of the motor housing in the same manner.
11. Put the motor back in the bottom part of
the fan housing. Make sure that the motor
rests properly between the two ”forks”
and on the small rubber gasket.