Mounting the Paper roll Holder
The paper roll holder consists of the following parts:
1 holder (aluminium profile)
1 left-side angle bracket with lock and lock arm
1 right-side angle bracket
1 square key
➊
Mark and drill holes as indicated in Fig. 1.
➋
Fix angle brackets onto the wall with 6 mm screws and plugs suited for the wall type
onto which the paper holder is to be mounted.
Please take note:
- that the aluminium profile must be assembled in the angle brackets before the last
bracket is attached to the wall.
- that the paper roll holder can only be closed when the lock arm is in horizontal
position.
- that the square key – and thus the lock arm – can only be turned when the key is
pressed into the actual lock cylinder.
➌
Rest a paper roll inside the paper holder and tip the holder towards the wall, making the
white locking devices click.
➍
Lock paper roll holder by turning the lock arm to vertical position.
Maintenance, cleaning and malfunction
The paper roll holder requires no specific maintenance, but regular inspection is
recommended.
Contact your supplier or DAN DRYER A/S immediately if the holder does not work properly.
The holder can be cleaned using a damp cloth. Use only neutral, liquid cleaning products.
You are responsible for making sure the holder is safe to use.
Accessory
DAN DRYER paper rolls Art.No. 657 and Art.No. 667 fit this paper roll holder.
Fig. 1
Paper Roll Holder
