DAN DRYER FOAMTAP 382, User Manual

• 

Ensure easy access to maintenance 

and cleaning of the unit.

• 

It is recommended to install a 

power switch to the soap dispenser 

to ensure easy disconnection of the 

electricity supply before cleaning 

and maintenance.

• 

Do not bend the hose too sharp. It 

can increase the resistance in the 

hose and reduce the ability of the 

pump to deliver a full dose.

• 

Ensure unit is installed on solid and 

stable background.

• 

Pay attention to the different 

properties of the different liquids, 

depending on the type of pump.

IMPORTANT!

USER GUIDE 

•  Place your hands approx. 10-14 cm under the sensor to activate the

   dispenser. The dispenser will deliver 1-1.5 ml soap (0.6-0.8 ml foam)

•  Remove hands after soap release

•  Stops automatically when hands are moved away

INSTALLATION HEIGHT

LIGHT INDICATOR

Standby

Solid green light 

Active

Pulsing light from green to red

Wrong type of soap/obstruction

Flashing green and red light

Empty soap reservoir*

Flashing green light

Sensor

Nozzle

* Light indication for empty soap reservoir is based on a counter that resets when power 

is switched off, e.g. when refilling soap. The calculation is based on a 1.5 L soap reservoir 

and will call for soap refill every 1.2 L (approx. 1000 activations). If using foaming soap 

the empty reservoir indication flashes even though the reservoir is still half full. Remove 

reservoir from wall bracket and place it back to reset the SoapTap unit.

CLEANING AND MAINTENANCE

Routine cleaning and maintenance is recommended.

CLEANING AND MAINTENANCE OF CONTROL BOX 

• Cut the power

• Remove any dust and dirt 

• Do not rinse with running water

• Use a damp cloth and mild cleaning solution. Never use cleaning detergents with  

  an abrasive effect

CLEANING AND MAINTENANCE OF TAP/SENSOR 

• Do not rinse with running water

• Use a damp cloth and mild cleaning solution. Never use cleaning detergents with  

  an abrasive effect

• Clean sensor for dust and dirt to prevent unintentional activation

REFILL OF SOAP RESERVOIR 

• Remove soap reservoir and pump unit from the control box

• Remove pump from soap reservoir and fill with soap

• Put the pump back in the filled reservoir. Install soap reservoir and pump in the control box

• NB! 

Do not 

remove the soft hose from the pump

D

Soap: D = ≤ 350mm

Foam: D = ≤ 650mm

8

9