TSM-0064 - TE27/32 4-Speed LD with Full Flow Control Valve Service Manual
Dana Holding Corporation
12
DRIVE PLATE INSTALLATION
Proper identification is determined by measuring the bolt circle diameter (see dimension “A” in the illustration below)
and then ordering the appropriate drive plate kit from the table.
1.
Position drive plate and weld nut assembly on torque converter assembly with weld nuts toward converter.
2.
Align intermediate drive plates and backing ring with holes in torque converter assembly.
3.
Two dimples 180
o
apart in backing ring must be facing outward toward engine flywheel (hollow side facing torque
converter assembly).
4.
Install capscrews and lockwashers. Tighten capscrews to 30-37 lbs. ft. (40-50 N•m).
NOTE:
Assembly of all plates must be completed within 15 minutes from when screws are installed. If a screw is removed for any reason it must be
replaced. The adhesive left in the tapped holes must be removed with the proper tap and cleaned with solvent. Dry the hole thoroughly and
use a new screw for reinstallation.
Each kit includes:
2 Intermediate Drive Plates
1 Drive Plate & Weld Nut Assembly
1 Backing Ring
6 Mounting Capscrews
6 Lockwashers
Instruction Sheet
Each kit includes:
3 Intermediate Drive Plates
1 Backing Ring
6 Mounting Capscrews
6 Lockwashers
Instruction Sheet
15” [381.0 mm] diameter
15” [381.0 mm] diameter
16” [406.4 mm] diameter
16” [406.4 mm] diameter
17” [431.8 mm] diameter
17” [431.8 mm] diameter
BACKING RING
INTERMEDIATE
DRIVE PLATES (2)
DRIVE PLATE AND
WELD NUT ASSEMBLY (1)
BOLT CIRCLE
DIAMETER
"A"
BACKING RING
INTERMEDIATE
DRIVE PLATES (3)
BOLT CIRCLE
DIAMETER
"A"
Summary of Contents for SPICER TE27
Page 2: ......