Kollmorgen
Unpacking and Inspecting
SERVO
STAR
®
SP3 Power Block
3
UNPACKING AND INSPECTING
Open the box and remove all the contents. Check to ensure there is no visible damage to any of
the equipment.
Electronic components in this amplifier are design-hardened to reduce static
sensitivity. However, proper procedures should be used when handling to avoid
damage to equipment.
Remove all packing material and equipment from the shipping container. Be aware
that some connector kits and other equipment pieces may be quite small and can be
accidentally discarded if care is not observed when unpacking the equipment. Do not
dispose of shipping materials until the packing list has been checked.
Upon receipt of the equipment, inspect components to ensure that no damage has
occurred in shipment. If damage is detected, notify the carrier immediately. Check all
shipping material for connector kits, documentation, diskettes, CD-ROM, or other
small pieces of equipment.
WARRANTY INFORMATION
All products covered in this manual are warranted to be free of defects in material and
workmanship and to conform to the specifications stated either in this document or product
catalog description. All Kollmorgen brushless motors and electronics are warranty for a period of
24 months from the time of installation or 30 months from time of shipment, which ever comes
first. There are no other warranties, expressed or implied (including the warranty of
merchantability and fitness for a particular purpose, which extends beyond this warranty.
Kollmorgen warrants that the products covered in the manual are free from patent infringement
when used for normal purposes.
USE AS DIRECTED
The following guidelines describe the restrictions for proper use of the SERVO
STAR
SP3
Power Block:
1.
The amplifiers are components built into electrical equipment or machines and can only
be used as integral components of such equipment.
2.
The servo amplifiers are to be used only on earthed three-phase industrial mains supply
networks (TN-system, TT-system with earthed neutral point).
3.
The servo amplifiers must not be operated on power supply networks without an earth or
with an asymmetrical earth.
4.
If the servo amplifiers are used in residential areas, or in business or commercial
premises, you must implement additional filter measures.
5.
The servo amplifiers are only intended to drive brushless synchronous servomotors with
closed-loop control of torque, speed, and position. The rated voltage of the motors must
be at least as high as the DC-link voltage of the servo amplifier.
www.szcxi.com | From
：
KOLLMORGEN
