Start operating your DanaLock
Move the Danalock in the nearby of your Vera Gateway approximately 1-2 meters.
The general Z-Wave range should be approximately 20 meters in use.
!
Including the DanaLock to your Z-Wave network
Put your gateway into inclusion mode.
Now include your DanaLock
DanaLock Circle: Touch the touch button in the middle of the face plate until you hear 2
beeps. The gateway and the DanaLock will now exchange security keys and set up the
default user configuration.
DanaLock Square: Touch the touch button on the side of DanaLock until you hear 2
beeps. The gateway and the DanaLock will now exchange security keys and set up the
default user configuration.
This may take longer then other Z-Wave devices, as this is a secure device, unlike a e.g. Z-
Wave relay.
When finished the DanaLock will shop up on you web interface.
Use the web interface to make sure you are able to lock and unlock the DanaLock.
NOTE: the Pin ability in the device is NOT activated on the current DanaLock
When you have a combined DanaLock with both Bluetooth Smart and Z-Wave, be sure to
set the time zone on your Z-Wave gateway. Otherwise the clock running in the DanaLock
will be off, and the time stamped key you send will not work due to the unsynchronized
clock.
To synchronize, simply set the time zone, then pres lock or unlock in your user interface. Be
sure it is the timezone where the DanaLock is installed you use.
Now attach the Danalock to your door following the steps in the attachment guide.
!
!
!
!
27
Summary of Contents for BT100 Circle
