Pair a Danapad V3 with a Danalock V3 Smart Lock
This guide covers how to pair the Danapad with a Danalock V3 Smart Lock. The Danapad wirelessly pairs with a
Danalock V3 Smart Lock to give customers a complete retrofit smart lock option.
Before pairing a Danapad with a Danalock V3 Smart Lock:
• Verify the Batch number located on the Danalock V3 box is 38777 or higher. Batch numbers below 38777 will
require a firmware update. For more information about updating firmware, see
How do I update the firmware on a
.
• Verify the Danalock V3 is not associated with a Z-Wave network. If it is, it will not enter pairing mode.
To pair a Danapad with a Danalock V3 Smart Lock:
1. Put the Danalock V3 into pairing mode.
a. Press the top button on the Danalock V3 with a pin or paperclip seven times and wait 5 seconds.
b. The Danalock V3 will blink in a red and green pattern to indicate that it is now in pairing mode.
c. The Danalock V3 will keep blinking while it waits for an accessory device connection.
Note
: The Danalock V3 will time out and exit pairing mode after 60 seconds.
2. Put the Danapad into pairing mode.
a. Hold the unlock button for 5 seconds.
Updated: Sat, 11 Sep 2021 05:59:47 GMT
1
