b. The Danalock V3 will blink in a red and green pattern to indicate that it is now in pairing mode.
c. The Danalock V3 will keep blinking while it waits for an accessory device connection.
Note
: The Danalock V3 will time out and exit pairing mode after 60 seconds without user input.
2. Put the Danapad into pairing mode.
a. Hold the unlock button for 5 seconds.
b. The Danapad will blink red and green to indicate that it is in pairing mode and awaiting user input.
Note
: The Danapad will time out and exit pairing mode after 60 seconds without user input.
c. Press
[2]
to unpair the Danapad from the Danalock V3. A green light indicates success, while a red light
indicates failure.
Note
: The Danapad can perform unpairing only when in proximity to the Danalock V3 while it is in pairing
mode.
d. After a successfully unpairing, the Danalock V3 and Danapad will both return to normal operation mode.
Frequently asked questions
How can I tell if a Danalock V3 can pair to a Danapad?
The Batch number located on the Danalock V3 box must be 38777 or higher for the Danalock V3 to be compatible with
a Danapad.
The Danalock V3 is already enrolled in a Z-Wave network. How do I pair it to the Danapad?
In order to pair the Danalock V3 to the Danapad, the Danalock V3 must be removed from the Z-Wave network. For more
information about removing devices from a Z-Wave network, see
Remove Z-Wave devices using the Partner Portal or
.
Updated: Sat, 11 Sep 2021 05:59:47 GMT
3
