4. Tap
OK
to confirm the deletion.
Once the lock is deleted from your phone, use the end of a paperclip to click the button in the small center hole on top of
the Danalock 10 times. A blinking red light on the lock will indicate the reset command. Wait five seconds for the
command to confirm. The Danalock V3 will now reset to factory settings.
Once the lock has been reset, see
To pair a Danapad with a Danalock V3 Smart Lock
.
How do I update the firmware on a Danalock V3 or Danapad?
To update firmware using an iOS device, see
https://danalock.com/support/ios-firmware-upgrade/
To update firmware using an Android device, see
https://danalock.com/support/android-firmware-upgrade/
.
Updated: Sat, 11 Sep 2021 05:59:47 GMT
5
