Index
Remove the old thumb turn on your
door, but please keep the screws that
held it for later use.
In the box you will find 2 tailpiece
extenders for flat and square
tailpieces, making your danalock
fit most deadbolts.
Now fasten the baseplate
with the screws that original
ly held the thumb turn and
cylinder piece.
Important! The cylinder tailpiece have to align with the
door surface.
Extend the tailpiece with one of the two
extenders before you mount the baseplate. The tailpiece
extender should stick out 10 mm from the baseplate.
Click the lid off your danalock with your
nails, or loosen the lid by gently turning
a screwdriver in the slot at the rim of
the shell.
Place your danalock on the base, be
sure the cylinder tailpiece fits in the
center.
Fasten the 3 base-screws.
Click the lid back on. Now Your
danalock is now ready for use.
10 mm
align with
the door
surface
The danalock comes with batteries inserted, but a thin plastic folio
guarantee that your new danalock is fully charged. Remove the folio
and the danalock lits up with a green light for 5-10 seconds.
Loosen the 3 base-screws placed right underneath the
printed circuit board with a screwdriver.
danalock App:
Adding a new lock
13
Adding a new lock
Open the main menu.
In the danalock App
press the menu button
on the top left corner
to add a new danalock.
This will make the
main menu swipe
in from the left.
Before you can add a new
lock to the system you have
to enable the Bluetooth
Smart Include Mode.
In order to make a connection
between your phone and your
danalock, you have to press and
hold your finger on the user
button until you hear 3 beeps.
Release the finger, and a short
beep is heard. Now your danalock
is in inclusion mode,
3 beeps
release finger
short confirm beep
Smartphone
Smartphone
