Index
Remove the old thumb turn on your
door, but please keep the screws that
held it for later use.
In the box you will find 2 tailpiece
extenders for flat and square
tailpieces, making your danalock
fit most deadbolts.
Now fasten the baseplate
with the screws that original
ly held the thumb turn and
cylinder piece.
Important! The cylinder tailpiece have to align with the
door surface.
Extend the tailpiece with one of the two
extenders before you mount the baseplate. The tailpiece
extender should stick out 10 mm from the baseplate.
Click the lid off your danalock with your
nails, or loosen the lid by gently turning
a screwdriver in the slot at the rim of
the shell.
Place your danalock on the base, be
sure the cylinder tailpiece fits in the
center.
Fasten the 3 base-screws.
Click the lid back on. Now Your
danalock is now ready for use.
10 mm
align with
the door
surface
The danalock comes with batteries inserted, but a thin plastic folio
guarantee that your new danalock is fully charged. Remove the folio
and the danalock lits up with a green light for 5-10 seconds.
Loosen the 3 base-screws placed right underneath the
printed circuit board with a screwdriver.
23
danalock App:
Auto unlock
Auto unlock
Auto unlock is a
nice feature that
unlocks your door
automatically when
yournear your door.
When Auto unlock is
on, your smartphone
will scan for danalocks
in the area.
As soon as the App
finds a danalock with
an e-key that matches
the ones you have in
your App Keychain, the
danalock will unlock
the door.
The App needs to be
running on your phone
to be able to Auto
unlock.
Auto unlock works best
if you hold
the smartphone in your hand, from
a bag or the pocket of a jacket.
If you have your mobile in the pocket
of a tight pair of jeans, the Bluetooth
signal might get distorted, causing
the Auto unlock to fail occasionally.
Entering
danalock’s
Bluetooth
range
unlocks
your door
Leaving the
range your
phone will
Auto unlock
again at next
proximity
As long as you are in
the Bluetooth area,
the App won’t react
