Index
Remove the old thumb turn on your
door, but please keep the screws that
held it for later use.
In the box you will find 2 tailpiece
extenders for flat and square
tailpieces, making your danalock
fit most deadbolts.
Now fasten the baseplate
with the screws that original
ly held the thumb turn and
cylinder piece.
Important! The cylinder tailpiece have to align with the
door surface.
Extend the tailpiece with one of the two
extenders before you mount the baseplate. The tailpiece
extender should stick out 10 mm from the baseplate.
Click the lid off your danalock with your
nails, or loosen the lid by gently turning
a screwdriver in the slot at the rim of
the shell.
Place your danalock on the base, be
sure the cylinder tailpiece fits in the
center.
Fasten the 3 base-screws.
Click the lid back on. Now Your
danalock is now ready for use.
10 mm
align with
the door
surface
The danalock comes with batteries inserted, but a thin plastic folio
guarantee that your new danalock is fully charged. Remove the folio
and the danalock lits up with a green light for 5-10 seconds.
Loosen the 3 base-screws placed right underneath the
printed circuit board with a screwdriver.
07
danalock installation:
Lock/unlock door with User button
Lock/unlock door
with User button
The User/touch button
gets activated when you
hold your finger on it.
The user button has
various purposes, and
it’s action depends on
how long you press it.
Note:
Depending on
how your deadbolt is
installed, to unlock your
door manually you must
turn the danalock the
opposite direction.
Read here for more
about lock direction.
Lock door:
To lock the door place your
finger on the user button
for no more than 1 second.
Release the finger, and
the danalock will start
a lock session.
Unlock door:
To unlock the door place your
finger on the user button
between 1 and 3 seconds.
Release the finger, and
the danalock will start a
unlock session.
Manual lock/unlock:
You can lock or unlock your
door by turning the danalock
with the hand just like a
thumb turn.
