danalock V3 BT HK SCANDI, Manual

26

27

LED-Mode

LED color

Status indication

Constant red till light finishes

Lock has successfully locked

Constant green till light finishes

Lock has successfully unlocked

Constant white for 3 seconds

Power on. Batteries are activated

Red light flashes every 5 minutes

Critical battery level

Constant purple

Firmware is being updated

Blue light flashes

Settings are changed/saved

LED-Signals

Configuring the Danalock V3 with click-commands

You can configure the Danalock via the button found in the small hole on 

the top of the lock. When you click through settings, the LED will change 

color according to the following scheme. When you get 

to the setting you want to change wait for 5 seconds and 

the Danalock will react to your command. This gives you 

plenty of time to navigate to the right command. If you 

make a wrong number of clicks, just stop at a number 

of clicks where the LED doesn’t light up and wait for 

5 seconds. The LED will flash red to indicate that it has 

timed out.

Clicks

Color

Activity

2

Yellow

Manual calibration

Start by turning the Danalock to the desired unlocked position. Start the calibration 
with the click command and wait for the LED to start blinking yellow. Turn the 
Danalock to the desired locked position while the LED blinks and click the button once 

to save the locked position. The Danalock will confirm with a green blink. 

If the lock doesn’t receive a response from you within 30 sec the calibration will be 
canceled.
3

White

Auto calibration

Start by turning the Danalock to unlocked position and lifting the handle if needed. The 
door has to be left open while the Danalock auto calibrates. Start the auto calibration 
with the click command. The Danalock will blink white while auto calibrating.