Danby DAR044A6BSLDBO, Owner'S Manual

OFF

Max

Min

TEMPERATURE SELECTION

The temperature of the appliance can be adjusted 

by turning the thermostat dial. 

The larger dots indicate the coldest setting.

The smaller dots indicate the warmest setting.

The “OFF” position will turn off the cooling function.

Internal temperature of the appliance can vary 

based on ambient temperature, the quantity of items 

stored and how frequently the door is opened.

4

LEVELING INSTRUCTIONS

There is an adjustable foot on the bottom of the 

appliance that can be turned up or down to ensure 

that the appliance is level.

1.  Turn the adjustable foot counter-clockwise until 

the top of the foot is touching the bottom of the 

chassis.

2.  Slowly turn the adjustable foot clockwise until the 

appliance is level.

OPERATING INSTRUCTIONS

INTERIOR LIGHT

If the light bulb burns out, it can be replaced by 

following the steps below. Ensure the appliance is 

unplugged before replacing the light bulb.

1.  Remove the screw from the center of the light 

cover and pull the cover downward.

2.  Remove the old light bulb and discard. Replace 

with a 15 watt light bulb.

3.  Replace light cover.

1. Solid feet

2. Adjustable foot

3.  Adjustable foot hinge plate

4. Non-locking casters

5.  Larger locking caster

6.  Caster hinge plate

7.  Smaller locking caster

CASTER INSTALLATION

To reduce the risk of personal injury or property 

damage, we recommend unplugging the appliance 

and using two people to complete the caster 

installation.

1.  Place the appliance on its back. Protect the fl oor 

and the back of the unit from damage by laying 

the appliance on a towel or blanket.

2.  Remove the three solid feet. Unscrew the 

adjustable foot. Keep the solid feet and 

adjustable foot for future use.

3.  Install the non-locking casters on the back of the 

appliance where the mounting holes are already 

pre-drilled and threaded.

4.  Install the larger locking caster at the front of the 

appliance opposite the hinge.

5.  Remove the hinge plate installed on the 

appliance and replace it with the hinge plate 

provided in the caster box.

6.  Install the smaller locking caster into the pre-

drilled hole in the caster hinge plate.

7.  Once completed, allow the unit to stand upright 

for a minimum of 6 hours to avoid damage to 

internal components.

1

2

3

4

5

6

7

1

1