5
OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the three screws from the back of the
worktop, lift the back of the worktop and pull it
toward the front of the appliance to remove it.
Remove the worktop hinge hole cover from the
left side of the worktop and move it to the hinge
hole on the right side of the worktop.
2. Remove the screw from the door spindle cover
and remove the upper right hinge and door
from the cabinet. Remove the door spindle from
the upper right hinge.
3. Remove the lower hinge hole cover from the
bottom left side of the door and move it to the
bottom right side of the door.
4. Remove the adjustable foot and the two screws
holding the bottom hinge. Move the bottom
hinge to the left side of the cabinet and install
with the screws. Install the adjustable foot on the
left side of the appliance and move the solid foot
to the right side of the appliance.
5. The upper left hinge is in the accessory bag
inside the appliance. Install the door spindle
on the upper left hinge. Install the upper left
hinge and door onto the cabinet. Install the door
spindle cover with a screw. Reinstall the worktop
by laying it on top of the appliance and pushing
it toward the back until it clicks into place and
then reinstall the three screws at the back.
Note:
When reinstalling the door, ensure that the
top of the door is level with the top of the cabinet
and that the rubber gasket makes a good seal with
the cabinet all the way around.
Note:
Images are for instructional purposes only.
Your appliance may appear slightly different.
A. Worktop Hinge Hole Cover
B. Worktop
C. Door Hinge Hole Cover
D. Door Spindle Cover
E. Door Spindle
F. Lower hinge hole cover
1
2
3
4
5
