INSTALLATION INSTRUCTIONS
5
LOCATION
• Two people should be used when moving the appliance.
• Remove interior and exterior packaging prior to installation. Wipe
the outside of the appliance with a soft, dry cloth and the inside with
a lukewarm wet cloth.
• Place the appliance on a fl oor that is strong enough to support it
when it is fully loaded.
• Do not place the appliance in direct sunlight or near sources of heat,
such as a stove or heater, as this can increase electrical consumption.
Extreme cold ambient temperatures may also cause the appliance to
perform improperly.
• Do not use the appliance near water, for example in a wet basement
or near a sink.
• Before connecting the appliance to a power source, let it stand
upright for approximately 6 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
• This appliance is 54.2 cm (21.3 inches) wide by 85.2 cm (33.5
inches) high by 58.5 cm (23 inches) deep.
• Allow 12.7 cm (5 inches) of space between the back, sides and top
of the appliance and all adjacent walls.
• This appliance is intended for free-standing installation only and
is not intended to be built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
• IMPORTANT:
Ensure that the door is fully closed when the appliance
is in operation. Failure to fully close the door can lead to excessive
condensation and potential water damage to fl ooring under the
appliance. Danby will not be responsible for damages from misuse.
• IMPORTANT:
This refrigerator is intended for household use only. It is
not designed for outside installation, including anywhere that is not
temperature controlled, e.g., garages, porches, vehicles, etc.
