Operating Instructions
NOTE:
The control panel of the unit you purchased may be slightly different depending on the model number.
CONTROL PANEL INSTRUCTIONS
CASTOR INSTALLATION (some models)
Castor installation is recommended to avoid damage to
fl
oors.
1. Remove the castors from the bucket of the dehumidi
fi
er.
2. Position the dehumidi
fi
er on its side.
3. Locate the arrow on the bottom of the dehumidi
fi
er and insert the castor
according to the arrow direction.
4. Slide the castor in as far as it will go. The castor will snap into place.
5. Repeat steps 1 to 4 for the other 3 castors.
5
When you push the button to change operation modes, the unit will make a beeping sound to indicate that it is
changing modes.
1. Continue
Button:
Press to activate the continuous dehumidifying operation.
2. Filter
Button:
This product has a check
fi
lter feature that is a reminder to clean the air
fi
lter for more ef
fi
cient oper-
ation. The check
fi
lter light will illuminate after 250 hours of operation. To reset this function after cleaning the
fi
lter,
press the reset
fi
lter button and the light will go off.
3. Fan
button:
Controls the fan speed. Press to select either high (turbo) or normal fan speed. Set the fan control to
high for maximum moisture removal. When the humidity has been reduced and quiet operation is perferred, set the
fan control back to normal.
4. Power
Button:
Press to turn the dehumidi
fi
er on or off.
5. (
/
) Buttons:
The humidity level can be set within a range of 35% RH (Relative Humidity) to 85% RH in 5%
increments using these buttons. For drier air, press the (
) button and set to a lower percentage value (%). For more
damp air, press the (
) button and set a higher percentage value (%).
6. Timer
Button:
Press to initiate the auto-start and auto-stop feature. Set a start or stop time from 0.0 to 24 hours using
the (
) and (
) keys.
7. Display:
Shows the actual (± 5% accuracy) room humidity level in a range of 30% RH to 90% RH. Otherwise, dis-
plays selection when programming humidity or timer.
8. Comfort:
This function allows you to be comfortable by automatically adjusting the humidity level with the
fl
uctuating
room temperatures. The humidity level cannot be adjusted in this setting.
Note: The fan does not shut off the moment you remove the bucket, the fan will shut off after 2-3 minutes.
1
6
3
2
7
4
5
8
10
9
