Operating Instructions
NOTE:
The control panel of the unit you purchased may be slightly different depending on the model number.
CONTROL PANEL INSTRUCTIONS
CASTOR INSTALLATION
Castor installation is recommended to avoid damage to
fl
oors.
1. Remove the castors from the bucket of the dehumidi
fi
er.
2. Position the dehumidi
fi
er on its side.
3. Locate the arrow on the bottom of the dehumidi
fi
er and insert the castor
according to the arrow direction.
4. Slide the castor in as far as it will go. The castor will snap into place.
5. Repeat steps 1 to 4 for the other 3 castors.
5
1. Smart
Dehumidify:
This function will automatically adjust the humidity level with the
fl
uctuating room temperatures.
The humidity level cannot be adjusted in this setting, it will stabalize between 45% - 55%.
2. Filter
Button:
The check
fi
lter light will illuminate after 250 hours of operation to remind you to clean the
fi
lter. To reset
this function after cleaning the
fi
lter, press the
fi
lter button and the light will go off.
3. Continuous
Button:
Press to activate the continuous dehumidifying operation, which will run the compressor contin-
uously in order to pull as much water from the air as possible.
4. Fan
button:
Controls the fan speed. Press to select either high or normal fan speed. Set the fan control to high for
maximum moisture removal. When the humidity has been reduced and quiet operation is preferred, set the fan control
back to normal.
5. Timer
Button:
Press to initiate the auto-start and auto-stop feature. Set a start or stop time from 0.0 to 24 hours using
the ( ) and ( ) buttons.
6.
Buttons:
The humidity level can be set within a range of 35% RH (Relative Humidity) to 85% RH in 5%
increments using these buttons. For drier air, press the ( ) button and set to a lower percentage value (%). For more
damp air, press the ( ) button and set a higher percentage value (%).
7. Power
Button:
Press to turn the dehumidi
fi
er on or off.
8. Display:
Shows the actual (± 5% accuracy) room humidity level in a range of 30% RH to 90% RH. Otherwise, dis-
plays selection when programming humidity or timer.
Note: The fan does not shut off the moment you remove the bucket, the fan will shut off after 2-3 minutes.
1
2
3
4
5
6
7
8
9
10
