1. Auto-defrost:
When frost builds on the evaporator
coils, the compressor will cycle off and the fan will
continue to run until the frost disappears.
2. Bucket Full Light:
The light will illuminate when the
bucket is full or incorrectly positioned inside the
cabinet. The compressor and fan operation are
terminated as a safety feature. When the bucket is
emptied or correctly re-positioned the dehumidifi er
will resume operation automatically.
3. Display:
Shows the actual (± 5% accuracy) room
humidity level in a range of 30% RH to 90% RH.
Otherwise, displays selection when programming
humidity or timer.
4. Drain Pump Button:
Connect the provided drain
hose and press this button to active the drain pump.
The pump light will illuminate.
5. Smart Dehumidify:
This function will automatically
adjust the humidity level with the fl uctuating room
temperatures. The humidity level cannot be adjusted
in this setting, it will stabilize between 45% - 55%.
6. Filter Button:
The check fi lter light will illuminate after
250 hours of operation as a reminder to clean the
fi lter. To reset this function after cleaning the fi lter,
press the fi lter button and the light will go off.
7. Continuous Button:
Press to activate the continuous
dehumidifying operation.
8. Fan button:
Controls the fan speed. Press to select
either high or normal fan speed. The light will
illuminate on high fan speed.
9. Timer Button:
Press to initiate the auto-start and
auto-stop feature. Set a start or stop time from 0.0 to
24 hours using the ( ) and ( ) keys.
10. ( / ) Buttons:
The humidity level can be set
within a range of 35% to 85% relative humidity in
5% increments. For drier air, press the ( ) button
and set to a lower percentage value. For more damp
air, press the ( ) button and set a higher percentage
value.
11. Power Button:
Press to turn the dehumidifi er on or
off.
OPERATING INSTRUCTIONS
4
CONTROL PANEL
1
2
3
4
5
6
7
8
9
10
11
TIMER FUNCTION
Auto Off Function
1. When the appliance is turned on, press the timer
button to activate the auto-stop timer. The auto-
stop light will illuminate.
2. Press the up and down buttons to change the set
time in 0.5 hour increments up to 10 hours and
then in 1 hour increments up to 24 hours.
3. Press the timer button to confi rm programming.
Auto On Function
4. When the appliance is turned off, press the
timer button to activate the auto-start timer. Set
the time as per the instructions above. Press the
timer button again to confi rm programming.
The auto on and auto off functions can be used at
the same time by fi rst setting one and then the other.
Both indicator lights will illuminate and the display
will count down to the appliance either turning off
or on, whichever function was set fi rst.
Note:
The timer will not cycle the appliance on and
off indefi nitely. The auto on and auto off timers will
function one time and then the appliance will return
to regular functioning.
Turning the appliance on or off at any time or
changing the timer setting to 0.0 will cancel the
timer settings.
MEMORY AND AUTO RESTART SETTINGS
Each time the appliance is disconnected or
reconnected or in the event of a power failure, the
appliance will default to the last program setting
that was used.
If the appliance shuts off unexpectedly due to
a power failure, it will restart with the previous
settings automatically once power resumes.
