OPERATION
To avoid vibration, the cabinet must be set level.This is accomplished by adjusting the
(2) front leveling legs located under the freezer cabinet. To start the freezer, turn the
temperature control to the position corresponding to the desired cooling.
0 = No Cooling
1= Minimum Cooling
3, 4 = Medium Cooling
7= Maximum Cooling
The freezer temperature will vary depending on the quantity of the food stored and
on the frequency with which the door is opened.
OPERATING INSTRUCTIONS
Maximum cooling
CAUTION:
To avoid personal injury to yourself and/or property,
we recommend someone assist you during the door reversal
process.
1)
To access the lower hinge assembly, tilt back the freezer cabinet
(Fig.A)
2)
Remove both leveling legs located at the front of the cabinet.
3)
Remove the screws holding the lower hinge assembly to the
cabinet.
4)
Remove the main door assembly from the freezer cabinet (lift
door slightly and pull downward).
5)
Using a flat head screwdriver, remove the main door top hinge
pin.(Fig.B)
6)
Re-install the main door top hinge pin on the opposite side of
the cabinet.
7a)
Remove the door plug and door bushing located on the top of
the main door.
7b)
Interchange their positions (eg.door plug right side, door
bushing left side).
8)
Re-install main door assembly on cabinet.
9)
Remove door bushing (bottom door) and install on opposite
side.
10)
Re-install the lower hinge assembly on the opposite side.
11)
Make sure the door assembly is properly aligned on the
cabinet before tightening lower hinge screws.
12)
Re-install both leveling legs. The process is now complete.
Fig. A
Fig. B
DOOR REVERSAL INSTRUCTIONS
Use a 10mm socket with
ratchet to remove / install the
hinge.
3
DEFROSTING
INSTRUCTIONS
Defrost and clean your freezer when frost has built up to about 1/4’(6mm) thickness. Complete defrosting and
cleaning should be done at least once a year. In high humidity areas, a freezer may need more frequent defrost-
ing and cleaning.
IMPORTANT:
Do not use an ice pick, knife or other sharp-pointed tool to defrost freezer. Damage can occur.
1)
Turn temperature control to ‘0’(off) and unplug power cord.
2)
Remove all frozen food.Wrap frozen food in several layers of newspaper and cover with a blanket: food will
say frozen for several hours.
OR
Store frozen food in a cooler, additional refrigerator-freezer or in a cool area.
3)
Remove frost.
4)
Wipe water from walls and bottom of freezer with a towel or sponge.
5)
Wash inside walls.
6)
Rinse and dry thoroughly.
7)
Replace all frozen food.
8)
Plug in power cord and refer to “Operation.”
